LG Electronics LRSC21951ST manual Push, How to dismantle parts, Care and maintenance

Care and maintenance

How to dismantle parts

NOTE

•Dismantling is done in the reverse sequence of assembly.

Be sure to unplug the power plug before dismantling and assembly. Never apply severe force to dismantle parts. Parts may be damaged.

Freezer

compartment

lamp

Dispenser lamp

Freezer

compartment

shelf

Door rack and support

Ice storage bin

After dispenser

is used

Separate the lamp by pulling it out (➂) while slightly striking (➀) and rotating (➁) the lamp cover.

Turn the bulb counterclockwise. Max. 40 W bulb for refrigerator is used and can be purchased at a service center.

Seperate the lamp by pulling it out, and then remove the lamp. Max. 15 W bulb for refrigerator is used and can be purchased at a service center.

To remove a shelf, lift the left part of the shelf a bit, push it to the direction ( ), lift the right part to the diretion ( ), and take it out.

Lift the door rack holding both sides ( ) and pull it out to ( ) direction.

Hold the ice storage bin as shown in the right figure and pull it out ( ) while slightly lifting it ( ).

It is recommended not to dismantle the ice storage bin unless it is necessary.

Be sure to use both hands when removing the ice storage bin, so as not to drop it on the floor.

If the ice storage bin does not fit well, slightly rotate the rotating device.

The water collector has no self-drainage function. So it should be cleaned regularly. Remove the cover by pressing the left side of water collector cover and dry it with a cloth. Press the point marked as shown in the figure to the right to remove the water collector cover.

132

FRZ	MIN	MAX	LOCK	LOCK
REFDISPENSERTEMP	WATER MINCRUSHED	CUBEDMAX	ROOMTEMPOFFON	SUPERFRZ

2

2

21

FRZP		FRZP
TEMPMIN		TEMPMIN
REF		REF
DISPENSERMINMAX		DISPENSERMINMAX
WATER MAXLOCK		WATERCRUMAXLOCK
CRUSHED	ONLOCK	SHED	ONLOCK
	ROOMSUPERFRZ	CUBED	ROOSUPERFRZ
CUBEDF			FF
	TEMP		TEMP
			PUSH
	PUSH

24