Installation
Door removal
Warning
Remove Lower
Cover and
Water Feed Tube
Electric Shock Hazard
Disconnect electrical supply to refrigerator before installing. Failure to do so could result in death or serious injury.
If your entrance door is too narrow for the refrigerator to pass through, remove the refrigerator door and pass the refrigerator laterally.
Remove the lower cover by lifting upward, and then pull up the water feed tube while pressing area shown in the figure to the right.
Lower Cover
Water Feed Tube
NOTE
•If a tube end is deformed or abraded, trim the part away.
Disconnecting the tube under the door causes about 1.5 litters water to flow out. Please put up a big container to prevent it.
Remove the
Freezer
Compartment
Door
1) Remove the hinge cover by loosening the screws. Disconnect all connections except the ground line.
Upper Hinge
2) Remove the keeper by rotating it counter clockwise and then lifting the upper hinge up .
NOTE
Hinge
Cover
Keeper
Connection
Wires
Earth Line
Upper Hinge
Remove the
Refrigerator
Door
•When removing the upper hinge, be careful that the door does not fall forward .
3) Remove the freezer compartment door by lifting it upward. This time, the door should be lifted enough for the water feed tube to be completely pulled out.
Lower hinge
NOTE
•After removing the door, take it into the kitchen where you are installing the refrigerator. Lay it down on a blanket and be careful to avoid damaging the water feed tube.
1) Loosen the hinge cover screws and remove the cover. Remove connection wire, if any, except for the ground line.
| Connection |
|
| Wires |
|
2) Remove keeper by rotating it clockwise | Upper Hinge | Keeper |
| ||
|
| |
and then remove the upper hinge by lifting |
|
|
it up . |
|
|
3) Remove the refrigerator compartment door by lifting it up.
8 | Lower Hinge |
