Door replacementFeed water tube installation
Push the refrigeratorsideways throughthe
entrancedoor as shownin the right picture.
Automatic icemaker operation needs water pressure of 21.3~121psi(lb/inch2) (That
is, a 7oz. paper cup willbe filled within 3 sec.).
If water pressure does not reach the rated 21.3psi (lb/in² or below), it is necessary
to purchase a separate pressure pump for normal automatic icemaking and cool
water feed.
Keep the total length of the water feed tube within 40 feet and be careful not to
bend or kink the tube. If the tube is longer than 40 feet, the icemaker and water
dispenser will notoperate properly.
Install the water feedtube at a place free from heat.
Connect to potablewater supply only.
Refer to instructionswith water filter kit for installation.
Mount the doors in the reverseorder of
removal after the refrigerator is brought to
the installation area.
Move the
Refrigerator
Before
Installation
Warning
Installation
9
Water Connection Instruction Guide
Read all directions carefully before you begin.
Connecting
theRefrigerator
to aWater Source
•
If operatingthe refrigerator beforeinstalling the water connection, turn icemaker
to theOFF positionto prevent operation without water.
•
All installations must be in accordance with localplumbing code requirements.
•
Use copper tubing and check forleaks.
•
Install coppertubing only in areas wheretemperatures will remainabove freezing.
•
It may take up to24 hours for your icemaker to beginproducing ice.
IMPORTANT
Standard screwdriver
7/16-inch and 1/2-inch open-end wrenches or two adjustable wrenches
1/4-inch nut driver
1/4-inch drill bit
Hand drill or electric drill (properly grounded)
Tools Required
•
Your refrigeratordealer has a kit available with a 1/4-inchsaddle-type shut-off valve,
a union, and copper tubing. Before purchasing,make sure a saddle-type valve
complies with your localplumbing codes. Do not use a piercing-type or 3/16-inch
saddle valve whichreduces water flow and clogs more easily.
NOTE
Screwdriver
Adjustable wrenches
Electric drill
NOTE:
Check the direction of the lever hinge.
Correct Incorrect