Door replacement Feed water tube installation
Push the refrigerator sideways through the
entrancedoor as shown in the right picture.
Automatic icemaker operation needs water pressure of 21.3~121psi(lb/inch2) (That
is, a 7oz. paper cup will be lled within 3 sec.).
If water pressure does not reach the rated 21.3psi(lb/inch2) or below, it is necessary
to purchase a separate pressure pump for normal automatic icemaking and cool
water feed.
Keep the total length of the water feed tube within 40 feet and be careful not to
bend or kink the tube. If the tube is longer than 40 feet, the icemaker and water
dispenser will not operate properly.
Install the water feed tube at a place free from heat.
Connect to potable water supply only.
Refer to instructions with water lter kit for installation.
Mount the doors in the reverse order of
removal after the refrigerator is brought to
the installation area.

Move the

Refrigerator

Before

Installation

WARNING
Installation
9
Water Connection Instruction Guide
Read all directions carefully before you begin.

Connecting

the Refrigerator

to a Water Source

Your refrigerator dealer has a kit available with a 1/4-inch saddle-type shut-o valve,
a union, and copper tubing. Before purchasing, make sure a saddle-type valve
complies with your local plumbing codes. Do not use a piercing-type or 3/16-inch
saddle valve which reduces water ow and clogs more easily.
NOTE
Screwdriver
Adjustable wrenches
Electric drill
NOTE:
Check the direction of the level hinge.
Correct Incorrect