LG Electronics MS3447GRS Installation, Installing, Earthing Instructions, 10cm, Green-and-yellow

INSTALLATION

BEFORE YOU BEGIN, READ THE FOLLOWING INSTRUCTIONS COMPLETELY AND CAREFULLY.

INSTALLING

1.Empty the microwave oven and clean inside it with a soft, damp cloth. Check for damage such as misaligned door, damage around the door or dents inside the cavity or on the exterior.

2.Put the oven on a counter, table, or shelf that is strong enough to hold the oven and the food and utensils you put in it. (The control panel side of the oven is the heavy side. Use care when handling.)

3.Do not block the vent and the air intake openings. Blocking vent or air intake openings can cause damage to the oven and poor cooking results. Make sure the microwave oven legs are in place to ensure proper air flow.

4.The oven should not be installed in any area where heat and steam are generated, because they may damage the electronic or mechanical parts of the unit.

Do not install the oven next to a conventional surface unit or above a conventional wall oven.

5.Use microwave oven in an ambient temperature less than 104°F(40°C).

6.Place the microwave oven on a sturdy and flat surface at least 10 cm(4 inches) from the wall.

7.Place the microwave oven as far away as possible from TV, RADIO, COMPUTER, etc., to prevent interference.

10cm

EARTHING INSTRUCTIONS

This microwave oven is designed to be used in a fully earthed condition.

It is imperative, therefore, to make sure it is properly earthed before servicing

WARNING-

THIS APPLIANCE

MUST BE EARTHED

IMPORTANT

The wires in this mains lead are colored in accordance with the following code:

Green-and-yellow:	Earth
Blue:	Neutral
Brown:	Live

As the colors of the wires in the mains lead of this appliance may not correspond with the colored markings identifying the terminals in your plug, proceed as follows.

The wire which is colored green-and-yellowmust be connected to the terminal in the plug which is marked with the letter E or by the earth symbol ( ) or colored green or green-and-yellow.

The wire which is colored blue must be connected to the terminal in the plug which is marked with the letter

Nor colored black.

The wire which is colored brown must be connected to the terminal in the plug which is marked with the letter L or colored red.

Copyright © 2007 LG Electronics. Inc. All right reserved.	3-1	LGE Internal Use Only
Only for training and service purposes