Rack Installation
Typical Rack Installation
1.(Optional) As shipped, the OAT100R mounting brackets are attached flush with the front of the unit (see diagram a). If desired, the mounting brackets may be detached from the unit and reattached, for example, so that they are flush with the rear of the unit (see diagram b). If you wish to change the location/orientation of the mounting brackets, carefully remove each of the four (M4 x 10 mm) screws and attendant washers (one flat and one lock washer per screw) holding each bracket in place. Then, use the same screws and washers to reattach the mounting brackets in the desired location.
2.Carefully slide the chassis into a standard
3.Use all four mounting screws to secure the chassis to the rack.
(a)
PWR | STATUS | SERVICE |
| PORT |
To rack
To rack
(b)
|
|
|
|
|
|
|
|
|
| |||
|
|
|
|
|
|
|
|
|
| |||
|
|
|
|
|
|
|
|
|
| |||
|
|
|
|
|
|
|
|
|
| |||
|
|
|
|
|
|
|
| Feature Control |
|
| ||
|
|
|
|
|
|
|
|
|
|
| ||
|
|
|
|
|
|
|
|
| Port | Port | POWER |
|
|
|
|
|
|
|
|
|
|
|
| 12V | Use flat washer and |
|
|
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
|
|
| lock washer with each |
|
|
|
|
|
|
|
|
|
|
|
| M4 x 10 mounting |
|
|
|
|
|
|
|
|
|
|
|
| bracket screw. |
12 |