Troubleshooting (Cont.)
Receiver Reception (Cont.)
A
Access the OAT100R System Status (via GUI) or System Monitor (via command line) display and observe the system configuration data.
Check that the OAT100R output
mode (RF or IP) is properly
configured. If necessary,
reconfigure the output mode as
described in this document.
Check |
|
|
| ||
receiver(s). | Yes | End | |||
Problem |
|
|
| ||
solved? |
|
|
| ||
| No |
|
|
| |
|
|
|
| ||
|
|
|
|
|
|
|
|
|
|
| |
Redisplay the OAT100R |
|
| Note: Typically, output | ||
System Status (via GUI) or |
|
| |||
|
| bitrates should be greater | |||
System Monitor (via command |
| ||||
| than 1 Mbps. | ||||
line), and check the ouput |
|
| |||
|
|
| |||
bitrates for each tuner. |
|
|
| ||
|
|
|
|
|
|
|
|
|
|
|
|
Bitrates at | Yes | Go to | ||
ideal level for | ||||
| Chart C | |||
all tuners? |
| |||
|
| |||
| No |
|
| |
|
|
| ||
|
|
|
| |
For each tuner, access the
Tuner Menu (via GUI) or Tuner
Information display (via
command line), and make sure at least one program is enabled for each tuner channel.
If applicable, enable one or
more programs on each tuner.
Check |
|
receiver(s). | Yes |
Problem | End |
solved? |
|
No |
|
Go to |
|
Chart B |
|
71 |