D Drill Hole Template

Hole Drilling Tools Required

- Drill Bit 1/4”
- Drill
- Phillips-Head #2 Screw Driver
- Center Punch
- Masking Tape
- Lightweight Hammer

Parts List

• Drilling Template
• 5-Phillips-Head M4 x 30mm Threaded
Screws (with lock and flat washers) use
for 3/4” thick desktop only.
(4-Required)
RJP-110F Remote Jack PackDesk Top Hole Drilling / Mounting Instructions
3/8" Max. Thread Depth
Desk Top
M4 Threaded Screw
RJP-110F
Determine
Thickness of
Desk Top
Select Screw Length
Based on Limitations
of Desk Top Thickness
and RJP Thread Depth

Drilling Setup and Procedure

1. Position hole drilling template on cabinet surface
or desk top.
2. Tape the template into position using the masking
tape.
3. Using the light-weight hammer and center punch,
make four hole drilling indents into the mounting
surface and remove the template.
Note: Be sure the hole drilling indents are suffi-
ciently deep enough to center and guide the drill
bit. Or, use a smaller size drill bit just to start the
hole recess.
4. Drill the four holes using the 1/4” drill bit.
5. Clean up and remove any residue from drilling the
holes.
6. Install the RJP on the desk top using the thread-
ed screws and lock washers provided*.
7. Tighten all screws securely.
8. Make all connections from the RJP, to the TV dis-
play panel and any other in-room resources etc.
9. Test RJP operation.
* The maximum depth the M4 screws can be thread-
ed into the RJP bosses is 3/8”. Use spacers if nec-
essary to compensate for excessive screw length.
Maximum screw length is 3/8” plus depth of cabi-
net or desk top.

Caution: Screw Length

Note: Length of the screws provided
(M4 x 30mm) is limited to usage for a
desk top thickness of 3/4 inches. For
other desk top thicknesses, determine
screw length allowing for the 3/8”
maximum thread depth of the RJP
screw holes.