LG Electronics SXS manual How to dismantle parts, Care and maintenance, Push

Freezer

compartment

lamp

Dispenser lamp

Freezer

compartment

shelf

Care and maintenance

How to dismantle parts

NOTE

•Dismantling is done in the reverse sequence of assembly.

Be sure to unplug the power plug before dismantling and assembly. Never apply severe force to dismantle parts. Parts may be damaged.

Separate the lamp by pulling it out (➂) while	1	3	2
slightly striking (➀) and rotating (➁) the lamp
cover.
Turn the bulb counterclockwise. Max. 40 W bulb

for refrigerator is used and can be purchased at a service center.

Seperate the lamp by pulling it out, and then remove the lamp. Max. 15 W bulb for refrigerator is used and can be purchased at a service center.

To remove a shelf, lift the left part of the shelf			2
a bit, push it to the direction (		), lift the right
part to the diretion (	), and take it out.

Door rack and support

Ice storage bin

After dispenser

is used

Lift the door rack holding both sides ( ) and pull it out to ( ) direction.

Hold the ice storage bin as shown in the right figure and pull it out ( ) while slightly lifting it ( ).

It is recommended not to dismantle the ice storage bin unless it is necessary.

Be sure to use both hands when removing the ice storage bin, so as not to drop it on the floor.

If the ice storage bin does not fit well, slightly rotate the rotating device.

The water collector has no self-drainage function. So it should be cleaned regularly. Remove the cover by pressing the left side of water collector cover and dry it with a cloth. Press the point marked as shown in the figure to the right to remove the water collector cover.

2

21

PUSH

PUSH

20