SIZING THE COMPACTOR

Carrier Lifting Capacity

Carrier

Oil Flow

Always use a compactor sized to the carrier. A compactor that is too small for the carrier will damage the compactor, while a compactor too big will damage the carrier. Ensure you have the proper installation kit for attaching the compactor and that the carrier's hydraulic system meets the compactor flow and pressure requirements.

The carrier that is selected to operate the compactor must have sufficient reach to compact the deepest area of the trench or excavation. Therefore,

sizing the compactor based on the carrier size becomes the most important factor in choosing the correct sized compactor.

BTI has assigned a 'Recommended Carrier Weight' range to each com- pactor. If the operating weight of the carrier falls within this range, the carrier will safely handle this model. If the desired compactor falls outside of the recommended carrier weight range, the carrier's lifting capacity and oil flow will need to be verified to ensure a proper fit.

Provided the weight of the compactor does not exceed the maximum lifting capacity of the carrier at any position, the carrier is assumed to be stable. On most loader backhoes and excavators, the maximum lifting capacity is lowest when the boom is at full reach. This is the value that must be compared to the operating weight of the compactor.

A required oil flow range is specified for each compactor, oil flow to the compactor within this range is adequate for operation. However, for maximum productivity the carrier should be capable of providing the maximum required flow. Compare the maximum oil flow requirement of the compactor with the oil flow capacity of the carrier. Remember the compactor will be operating at 1100-2100-psi (75-136 bar), therefore, oil flow should be evaluated at the operating pressure.

Below is the Carrier Sizing Chart, outlining the recommended carrier weight range for the compactor models.

16www.rockbreaker.com