T roubleshooting guide
| Symptom | Possible Cause | Solution |
|
| • Water supply it not adequate in area | Check another tap in the house. |
|
| • Water supply taps are not completely | Fully open tap. |
! | Caution | open. | Straighten hose(s). |
| No feeding. | • Water inlet hose(s) are kinked. | Check the filter of the inlet hose(s). |
| Check.... | • The filter of the inlet hose(s) are clogged. |
|
|
|
| |
|
|
| Clean and straighten the drain hose. |
|
| • Drain hose is kinked or clogged. | Clean the drain filter. |
! | Caution | • The drain filter is clogged. |
|
| No draining. |
|
|
| Check.... |
|
|
|
| • Load is too small. | Add 1 or 2 similar items to help |
|
| • Load is out of balance. | balance the load. |
|
| • The appliance has an unbalance | Rearrange load to allow proper |
|
| detection and correction system. If | spinning |
|
| individual heavy articles are loaded |
|
|
| (ex. bath mat, both robe, etc.), this |
|
|
| system may stop spinning or even |
|
|
| interrupt the spin cycle altogether. |
|
•If the laundry is still too wet at the end of the cycle, add smaller articles of laundry to balance the load and repeat the spin cycle.
• Is the door opened? | Close the door. | |
! Caution | ❋ If “ | ”is not released, call for service. |
|
| |
Door is opened. |
|
|
Close the door. |
|
|
| Unplug the power plug and call for service. | |
• Water overfills due to the faulty water | Close the water tap. | |
valve. | Unplug the power plug. | |
• Water level sensor has malfunctioned. | Call for service. | |
|
|
• Over load in motor.
• Over load in motor.
55