11
Preparation

RF coaxial connection

Connect the RF.OUTjack on the DVD+VCR to the
antenna in jack on the TV using the supplied 75-ohm
Coaxial Cable (R).

How to set the DVD+VCR’s RF output

channel

1. When the DVD+VCR is turned off, press and hold
CH (V/v) on the front panel for more than five
seconds. “RF03” or “RF04” appears in the display
window.
2. Press CH (V/v) to change the RF output channel
(RF03 or RF04). Tune the TV to this channel.
3. Turn off the DVD+VCR.

Audio/Video connection

1. Connect the DVD/VCR VIDEO OUT jack on the
DVD+VCR to the video in jack on the TV using
the video cable supplied (V).
2. Connect the Left and Right DVD/VCR AUDIO
OUT jacks on the DVD+VCR to the audio left/right
in jacks on the TV (A1) using the supplied audio
cables.
Note:
If you use this connection, set the TV’s source selector to
VIDEO.
Optional TV ConnectionsOptional TV Connections
These connections support only DVD playback. The
tuner and VCR still output through the RF.OUT(R) or
DVD/VCR OUT (A, V) jacks.

S-Video connection

Connect the S-VIDEO OUT jack on the DVD+VCR
to the S-Video in jack on the TV using the optional
S-Video cable (S).

Component Video / Progressive Scan

connection

If your television is a high-definition or “digital ready”
television, you may take advantage of the
DVD+VCR’s progressive scan output for higher
video resolution.
Connect the COMPONENT/PROGRESSIVE SCAN
VIDEO OUT jacks on the DVD+VCR to the corre-
sponding in jacks on the TV using an optional YPb
Pr cable (C).
Notes:
•Progressive scan does not work with the analog video
connections (yellow VIDEO OUTjack and S-VIDEO
OUTjack).
•When you use Component Video signal, set the
Progressive Scan to “Off” on the setup menu.
•If your TV does not accept the Progressive Scan format,
the picture will appear scrambled.

Audio connection

Connect the Left and Right AUDIO OUTjacks of the
DVD+VCR to the audio left/right in jacks on the TV
using the supplied audio cables (A2).