Freezer tray (depending on options)
You can use the freezer tray to gently freeze fruit (e.g. ber- ries or slices of fruit), herbs and vegetables for serving or garnishing.Spread the food out loosely on the tray (the pieces offruitwillretaintheirshapeand will not stick together).
Temperature display
(depending on options)
The thermometer shows the warm- est frozen food temperature. It is adjusted and designed so that only temperatures below 0°C are accurately displayed.
Defrosting
After the appliance has been in operation for some time, a layer of frost or ice will form on the inside walls. This increases energy consumption.
You should therefore defrost the appliance regularly.
•Switch the appliance off to defrost. Pull out the mains plug or remove/unscrew the fuse.
•Wrap the frozen food in paper or blankets and store in a cool place.
•Remove the plug from the drain opening. Remove the dividing wall or freezer tray and place
underneath the appliance
so that the defrosted water
escapes through the drain
opening into the dividing wall
or the freezer tray.
•Leave the lid open while de-
frosting. After defrosting mop
up the remaining water and
clean the appliance. If your appliance does not have a drain opening, wipe up the defrosted water with a sponge
or a cloth.
Do not use any mechanical devices or other artificial
aids for defrosting other than those recommended by the manufacturer.
GB
Cleaning
Before cleaning always switch off the appliance. Pull out the mains plug or remove/unscrew the fuse.
Clean the inside, equipment parts and outer walls with lukewarm water and a little detergent. Do not use abrasive or acid cleaners or chemical solvents.
Do not use steam cleaners because of the risk of injury and damage.
•Ensure that no cleaning water penetrates into the electrical com- ponents or ventilation grille.
•Dry all parts well with a cloth.
•The ventilation grilles should be cleaned regularly with a brush or vacuum cleaner. Dust deposits increase energy consumption. Ensure that none of the wires or other components are dislodged, bent or damaged.
Malfunctions
You may be able to rectify the following faults by checking the possible causes yourself:
• Appliance does not function, the control lamps are not lit: - Is the plug correctly fitted in the mains socket?
- Is the socket fuse intact?
• Loud running noise:
- Is the appliance set up firmly on the floor?
- Does the appliance cause nearby items of furniture or objects to vibrate? Please note that noises caused by the refrigerant circuit cannot be avoided.
• The temperature is not low enough:
- Is the temperature setting correct (see "Setting the tempera- ture")?
- Have excessive amounts of fresh food been placed in the appli- ance? Observe the temperature display for a further 24 hours.
- Does the separately installed thermometer show the correct read- ing?
- Is the ventilation system working properly?
- Is the appliance set up too close to a heat source? If none of the above causes apply and
you cannot rectify the fault yourself,
contact the nearest customer service 
department stating the type of ap- 
pliance 1, index 2and appliance 
number 3as indicated on the type 
plate. The 
the top of the 
the freezer.
Shutting your appliance down
If your appliance is to be shut down for any length of time, switch it off and disconnect the plug or remove the fuse.Clean the appliance and leave the lid open in order to prevent unpleasant smells.
The appliance complies with the relevant safety regulations and EC directives 2004/108/EC and 2006/95/EC.
All types and models are subject to continuous improvement and the manufacturer therefore reserves the right to make modifications to the shape, equipment and technology.
9
