Installation
1.Place the appliance in front of the installation recess.
2.Apply cover strips on the side walls of the appli-
ance.
3. Insert the bent section of the hose through the opening at the rear of the appliance.
4. Connect the hose to the solenoid valve 
at the front side of the appliance.
5. 5. Route the mains cable towards the socket.
6. Route the water hose | 6. |
towards the water shut- |
|
off tap. |
|
WARNING!
Do not connect the appliance to the power supply until the installation is completed.
CAUTION!
Lay the mains cable and the water hose in such a way that they will not be damaged when the appliance is slid into the installation recess.
7.Push the appliance slowly into the recess until the compressor mounting plate touches the
WARNING!
To prevent the appliance from tipping forwards, the com- pressor mounting plate must be touching the
Wall
Appliance
Compressor mounting plate
8.Connect the hose to the
Open the
Important!
After the ice maker has been switched on, the water supply system must be bled. See the section Bleeding the ice maker in the operating instructions.
9
