FIGURE 7
8

STEP 7:

FIGURE 8
• SECURELY assemble BACK PAD (14) to the RIGHT & LEFT PAD SUPPORTS (12) (13) using four 3/8 X 3” BOLTS (36) and
four 3/8” WASHERS (41) as shown in FIGURE 7.

STEP 8:

4
7
• Assemble one 1-1/4” RUBBER BUMPER (28) to the middle of the plate on the BENCH FRAME (7) as shown on FIGURE 8.
• Insert two 3/4” FLANGE BEARINGS (49) into the bushing of the LEG CURL/EXTENSION (9), then slide the 3/4” DIA TAPPED SHAFT
(51) into the 3/4” FLANGE BEARINGS (49) as shown in FIGURE 8.
13 12
41
36 3/8 X 3”
14
7
53
4
49
9
51
49
28 18
53
0123456
1/2 1/2 1/2 1/2 1/2 1/2
• SECURELY assemble two ROLLER PADS (4) to the BENCH FRAME (7) using one 19-1/4” TUBE (18) and two 1-5/16” SHAFT
COLLARS (53). SECURELY tighten set screws on SHAFT COLLARS (53). See FIGURE 8.