Life Fitness 9100HR manual How To... Install the Lifelink Upgrade KIT, REV 1 only

Life Fitness Model 9100HR (REV 1 & REV 2) Treadmill

How To... INSTALL THE LIFELINK UPGRADE KIT

TOOLS REQUIRED: Standard Screwdriver, Phillips Screwdriver, Hex Key Wrench Set, Pliers, Wire Cutters, Anti-Static Strap

WARNING: FAILURE TO OBSERVE SAFETY PROCEDURES WHEN SERVICING THIS UNIT

COULD RESULT IN INJURY FROM ELECTRICAL SHOCK

STEP 1

Turn the power off at the ON/OFF switch and unplug the unit at the wall outlet.

STEP 2

Ground yourself by positioning an anti-static strap around your wrist and attaching the other end (alligator clip or adhesive end) to a bare metal surface on the machine frame.

(REV 1 ONLY)

STEP 3

Remove the CONNECTOR COVER under the left side of the DISPLAY CONSOLE by removing the four screws with a Phillips screwdriver and unplug the 4 and 10-pin CONNECTORS to the DISPLAY CONSOLE.

STEP 4

Remove the DISPLAY CONSOLE by removing the four allen bolts and washers securing the DISPLAY CONSOLE to the HANDRAILS.

HINT: FOR EASIER REMOVAL, LOOSEN THE THREE SCREWS

HOLDING THE HANDLEBAR TO THE RIGHT SIDE HANDRAIL.

Remove the eight Phillips screws securing the console pan to the faceplate. Remove the LIFEPULSE ASSEMBLY by removing the four screws and

unplugging the 7-PIN CONNECTOR and the ground strap. Remove the ELECTRONIC BOARD from the faceplate by removing the eight screws and unplugging the RIBBON CABLE and STOP SWITCH CABLE.

STEP 5

NOTE THE ORIENTATION OF E-PROM BY THE U-NOTCH.

Remove and replace the E-PROM ( U1 ) with the E-PROM supplied in the upgrade kit. Return the DISPLAY CONSOLE to its proper position by reversing Steps 3 and 4.

STEP 6

Remove the four screws securing the MOTOR COVER in place and set the

MOTOR COVER aside.

STEP 7

Pull out the two RUBBER MOUNTING NUTS holding the FRONT PROTECTOR

SHIELD in position and remove it.

STEP 8

Remove the FRONT COVER by removing the four screws securing it in place.

STEP 9

Remove the two screws

securing the TRANSFORMER to the POWER BOX, lift the TRANSFORMER off and secure

the bracket supplied in the upgrade kit with the two screws

to the same holes. To ensure the NETWORK BOARD fits, remove the 3/16 allen bolt that holds the POWER BOX to the FRAME and replace it with the allen screw supplied in the upgrade kit. Slide the NETWORK BOARD (connector facing the front) on top of THE POWER BOX and secure it to the four existing holes with the four screws supplied in the upgrade kit. Take

the TRANSFORMER and secure to the top of the bracket with the two screws supplied in the upgrade kit.