BLOCK
PULLEY
BOLT
FIGURE 8FIENCHFRAME
STEP8:
A. Remove the BOLT, WASHERS,and LOCKNUTbelow the PULLEYin UPRIGHT.See FIGURE8.
B. Insert the threaded end of CABLE(part #6671001)under the PULLEYin UPRIGHTand around the bottom PULLEYof the PULLEYBLOCK.See FIGURE8.
C. Fasten end of CABLE(part #6671001) into threaded housing on the base of BENCHFRAMEand tighten jam nut securely.
D. Securely fasten previously removed BOLT,WASHERS,and LOCKNUT. (NOTE: The CABLE (part #667100l) should be routed over the bolt and washer.
7
