5.Assemble the PULLEY (11), OUTPUT CAM (12) and OUTPUT PLATE (13) using two M10 X 50mm BOLTS (14), four 3/8" SAE WASHERS (5) and two M10 NYLOCK NUTS (6) as shown. Tighten the BOLTS and NUTS securely.
6.Assemble the FRONT SHROUD (15) and REAR SHROUD (16) to the TOWER (3) using four M10 X 20mm BOLTS (17), four 3/8" SAE WASH- ERS (5) as shown. Be sure all tabs along the sides and top of the SHROUDS are fully engaged in the slots located inside the TOWER. Tighten the BOLTS securely. Do not overtighten the BOLTS.
7.Secure the OUTPUT CAM ASSEMBLY (A) to the TOWER AXLE (B) using one M10 X 25mm BOLTS (18), one 3/8" SAE WASHERS (5) and one PLATE (19) as shown. Tighten the BOLT securely.
IMPORTANT: Be sure the OUTPUT CAM ASSEMBLY is ori- ented as shown before securing it to the TOWER AXLE.
