1.Slide the ACCESSORY TRAY (#8) (if so equipped) over the

user right seat back post and down to make contact with the

SEAT HANDLEBAR.

2.Position the underside clamp bracket (A) around the SEAT HANDLEBAR and tighten the two clamp SCREWS and WASHERS (B).

NOTE: BE CAREFUL NOT TO OVER-TIGHTEN

THE SCREWS.

MISE EN GARDE : VEILLER À NE PAS TROP SERRER

LA VIS.

3. Align the four holes in the SEAT BACK (#5) with those in the SEAT BACK POSTS. Insert the four SCREWS (#1) and WASHERS (#2) through the backside of the SEAT BACK POSTS and into the SEAT BACK. Tighten the four SCREWS with a hex key wrench.

NOTE: BE CAREFUL NOT TO OVER-TIGHTEN

THE SCREWS.

MISE EN GARDE : VEILLER À NE PAS TROP SERRER

LA VIS.

4.Unfold the CONSOLE WIRE HARNESSES (C) from the POST extending from the FRAME.

5.Feed the WIRE HARNESSES at the top of the FRAME POST

through the bottom of the CONSOLE SUPPORT ASSEMBLY COLUMN. Continue pushing the WIRE HARNESSES until the CONNECTORS at the end of the WIRE HARNESSES exit

through the opening at the top of the COLUMN. Gently pull the 7 WIRE HARNESSES to remove the slack.

6.Position the CONSOLE SUPPORT ASSEMBLY (#6) so that

the HANDLEBAR is facing the user and slide the CONSOLE SUPPORT ASSEMBLY into the FRAME POST (D), being

4P

careful not to pinch the WIRES in the process. Align the holes in the top of the CONSOLE SUPPORT ASSEMBLY with those in the FRAME POST. Install the four CONSOLE SUPPORT ASSEMBLY BOLTS (#3) to secure it into position. Tighten the four CONSOLE SUPPORT ASSEMBLY BOLTS to 15-20 ft. lbs.

NOTE: BE VERY CAREFUL NOT TO DAMAGE THE WIRES WHEN PASSING THE BOLTS THROUGH THE HOLES. TIGHTEN THE BOLTS SECURELY.

MISE EN GARDE :FAITES ATTENTION TRÈS À NE PAS ENDOMMAGER LES FILS EN PASSANT LES BOULONS PAR LES TROUS. SERREZ LES BOULONS SOLIDEMENT.

CX

6

5P

14P

4

7. Align the LOCKING TABS of the 10-PIN CONNECTOR and

the 4-PIN CONNECTOR and plug them together until they

SNAP into place.

8. Carefully feed the wires back into the top of the CONSOLE

SUPPORT ASSEMBLY (#6) and attach the DISPLAY

CONSOLE (#7) to the CONSOLE SUPPORT ASSEMBLY

using the four CONSOLE SCREWS (#4) and a Phillips

screwdriver. Tighten the four SCREWS in a criss-cross

pattern.

NOTE: BE CAREFUL NOT TO OVER-TIGHTEN

THE SCREWS.

MISE EN GARDE : VEILLER À NE PAS TROP SERRER LA

VIS.

C 3

D

Page 6
Image 6
Life Fitness Classic Series manual Screws Mise EN Garde Veiller À NE PAS Trop Serrer LA VIS, Vis