Life Fitness SM22 manual Adjusting the pulleys

SM22 Assembly Instructions

You will be using 3/8” x 2-3/4” bolts in the configuration shown in Figure 1 to assemble this machine. Using a 9/16” socket and open end wrench:

1.Connect the Back Brace (#1) to the sides. Leave the bolts loose until all parts have been assembled.

2.Connect the Bottom Brace (#2) to the sides. Leave the bolts loose until all parts have been assembled.

3.Connect the Top (#3) to the sides. Leave the bolts loose until all parts have been assembled.

4.Go back and tighten all bolts. Overtightening the bolts will make it difficult to put the Caplug on the nut.

5.Place the Caplugs on all the Caplug washers.

6.Check to see that the weight stack pins slide easily into all weight plates.

7.Check to see that the pulley adjustment mechanism works correctly by lifting the handle (see Figure 2) and placing it into each of the two holes. Then attach a handle to the cable and lift the weight stack in each of the variable resistance positions.

Figure 4. Adjusting the pulleys.

5