Life Fitness T7-0, T5-5 user manual Securely 3 step from bolts upright 8 bottom the tighten Now

E

Needed Hardware

	B			A
		.(B) manual user the of section To How the
in page Belt Striding the Center to How See .belt striding the center to wrench key hex provided the use necessary, If
.nuts jam the with place in feet the lock level, is treadmill the Once .(A) feet leveling the using treadmill the Level			9

Size Actual
C
Needed Hardware
.them tighten over
not do but securely screws
the Tighten .screws removed
previously (2) the using cover
motor the Secure .frame
the to down front the lower
and clips the into cover motor
the slide upward, tilted cover
motor the of front the With
.cover motor the install-Re	8

.seated fully are they ensure to firmly Press .shown as locations respective their into tray CD and holders bottle water the Insert

7

Size Actual

D

C

Needed Hardware

.them tighten over not do but securely screws the Tighten .screws the tightening before covers bottom and top the of edges the align to sure Be .assembly bridge/console the to cover bridge the secure bottom, the from screws Phillips 3/8 x #6 (4) and top the from screws Phillips 1/2" x #10 (2) Using

6

	B		A
.upright right the of hole center the into cable excess any Feed .shown as
clips cable the through cable console the Route .(A) console display the of bottom the at located board console the to
assembly) bridge the (near jack cable remaining the Connect .(B) shown as board controller motor the to jack cable the
connect and hole access cable the through cable of 18" approximately pull Carefully .(B) shown as hole access cable
		5
bottom the out then and (A) upright right the of hole center the through down cable console the of end one Feed

Size Actual

B	A
	Needed Hardware

.securely 3) step (from bolts upright (8) bottom the tighten Now

.securely bolts (4) the Tighten .shown as washers tooth internal M10 (4) and bolts 25mm x M10 (4) using uprights the to assembly bridge/console the Bolt

4