Lightolier 0890 instruction sheet IV. A~ACH Mounting Ring, Clip Assembly Fig, Clip Removal Fig. J

IV. A~ACH MOUNTING RING LoT

Insert MOUNTING RING into CEILING as shown (Fig. H).

CLIP ASSEMBLY (Fig. 1)

1.Insert CLIP from inside housing, through ‘T’ slot.

2.Apply downward force with screwdriver on top of CLIP or engage screwdriver in slot in CLIPS flange.

3.Apply force until CLIP is snugly seated.

CLIP REMOVAL (Fig. J)

1.Insert a small blade, short-handled screwdriver through the CLIPS’S screwdriver slot, and press against the opposite side of the CLIP

2.Push CLIP up to top of ‘T’ SD and remove.

V. SNAPON (Fig. E) SEE SEPARATE

I REFLECTOR TRIM

INSTRUCTION

VI. PUSH-UP (Fig. F) SHEETS

					PRING
		FIG. H
		TO INSERT			INSIDE OF
		\		‘f	HOUSING
			‘.,	r	STEP 1
		Y
				,
			\...T1,(		SHORT HANDLE
	‘T	SLOT			SCREWDRIVER
	IN HOUSING			J
C“L”G\’&,			.		STEP 2
	7			*’	STEP 3
[‘w,.		LJ

LcI=lL1’G

FIG. I

FIG. J

t 4

WARNING: USE 0NL% REFLECiOR TRIMS PROVIDED BY LIGHTOLIER INC. USE OF UTHER MANUFACTURERS’ REFLECTOR TRIMS VOIDS THE UNDERWRITERS LABORATORIES LISTING AND

COULD CONSTITUTE A flRE HAZARD.