READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING FIXTURE
This fixture is intended for installation in accordance with the National Electrical Code and local regulations. To assure full compliance with local codes and regulations, check with your local electrical inspector before installation. To prevent electrical shock, turn off electricity at fuse box before proceeding.
Retain these instructions for maintenance reference.
INSTRUCTION SHEET NO.
IS:1104ICX
B1204 Page 1 of 2
INSTALLATION PROCEDURE FOR HIGH WATTAGE INSULATED CEILING
FRAME-IN KITS 1004ICX, 1004ICXN, 1104ICX, 1104ICXN,
NEW CONSTRUCTION
NOTE: I.C.
Fig. A | Fig. B | Fig. C | Fig. D | Fig. E | Fig. F |
WARNING: USE ONLY WITH LIGHTOLIER REFLECTOR TRIMS MARKED WITH I.C. LAMPING INFORMATION. USE OF OTHER MANUFACTURERS’ TRIMS VOIDS THE UNDERWRITERS LABORATORIES LISTING AND COULD CONSTITUTE A FIRE HAZARD
1.FRAME-IN (Fig. A)
Locate fixture along joist and line up bottom edge of HINGED MOUNTING BAR with the bottom of joist and fasten in place.
5 1/4” 1004ICX
5 5/8” 1104ICX
CENTER LINE OF
APERTURE OPENING
6 3/8” 1004ICX 6” 1104ICX
Note: Integral nail version available
HINGED MOUNTING BAR
BEND AT HOLE | TAB |
|
BEND AT TAB
For suspended ceilings:
•Rotate HINGED BAR ENDS to position shown and fully extend bars.
•Crimp bottom of edge of CHANNEL to prevent rotation of HINGED BAR ENDS.
•Bend
•Position notched area of MOUNTING BARS onto
•For suspended ceiling, make certain that bottom of Mounting Frame is no higher than 1” above ceiling line.
HINGED BAR ENDS |
CHANNEL
FOR JOIST SPACING LESS THAN 16” ON CENTER (TO 12” ON CENTER):
•MOUNTING BAR CHANNELS can be shortened and used as nailing legs in tight spaces. Simply remove INNER BAR from holed CHANNEL, bend CHANNEL at appropriate point and use extra screw to secure it to the joist. (Fig. G)
TAB
Fig. G
®LIGHTOLIER a GENLYTE THOMAS company. 631 Airport Road, Fall River, MA 02720
