READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING FIXTURE.
This fixture is intended for installation in accordance with the National Electrical Code and local or Federal code specifications. To assure full compliance with codes and regulations, check with your local electrical inspector before installation. To prevent electrical shock, turn off electricity at fuse box before proceeding.
Retain these instructions for maintenance reference.
INSTRUCTION SHEET NO.
IS:1102
B0203 | Page 1 of 2 |
Installation of Lytecaster®
WARNING – (RISK OF FIRE) Do not install insulation within 3 inches of fixture sides or wiring
compartments, nor above fixture in such a manner as to entrap heat.
1.FRAME-IN (FIG. A)
Fasten MOUNTING FRAME to wood joist.
NOTE: ADJUSTABLE MOUNTING can be extended for 24” mounting. (For suspended ceiling, make certain that the bottom of MOUNTING FRAME is no higher than 1” above ceiling line Fig. F).
2.CLOSE-IN (FIG. B)
Install plasterboard or other dry type ceiling, as required.. Hole in board can be cut either on the ground or after the board is nailed to the ceiling. Use MOUNTING FRAME opening as cut- ting guide. (Make sure ROTO CLIPS are rotated out of hole area to cut.)
NOTE: For wet plaster ceiling, use Plaster Ring Accessory (order separately).
No. 1960 for 1002
3. |
| See separate Instruction Sheet |
4. |
| for your choice of reflector trim. |
U.S. PATENT NO. 4,039,822
OTHER U.S. AND FOREIGN PATENTS PENDING.
® LIGHTOLIER a GENLYTE THOMAS company. 631 Airport Road, Fall River, MA 02720