ACCESSORIES Fig, CLOSE SNOOT OVER LAMP Fig, IS 26556MPC

READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING FIXTURE

This fixture is intended for installation in accordance with the National Electrical Code and local regulations. To assure full compliance with local codes and regulations, check with your local electrical inspector before installation. To prevent electrical shock, turn off electricity at fuse box before proceeding.

Retain these instructions for maintenance reference.

INSTRUCTION SHEET NO.

IS:26556MPC

0798	Page 2 of 2

ACCESSORIES (Fig. 2)

1.With SNOOT open accessories can be installed or removed.

2.INSTALLING ACCESSORIES: Push accessory(s) into SNOOT snapping them into ACCESSORY SPRINGS.

NOTE: There must always be (1) accessory or clear glass installed in the SNOOT for safety reasons. This FIXTURE takes (2) accessories maximum with or without CROSSBLADE.

3.REMOVING ACCESSORIES: Push ACCESSORIES out of

	ACCESSORIES SPRING. Push one ACCESSORY SPRING	Fig. 2
	against SNOOT if accessory is difficult to remove.	Fig. 2
	against SNOOT if accessory is difficult to remove.
	CROSSBLADE may be removed. Pull CROSSBLADE out of
	SNOOT.

LOCKING SCREW

ACCESS KNOB

CLOSE SNOOT OVER LAMP (Fig. 2)

1.Rotate SNOOT until SLOT mates with ACCESS KNOB.

2.Tighten ACCESS KNOB to secure SNOOT.

FIXTURE OPERATION (Fig. 3)

Plug MALE PLUG into a grounded female receptacle. Receptacle must provide 120V AT 60 Hz. Turn LAMP on or off by activating the switch.

SETTING HORIZONTAL ROTATION

1.Loosen LOCKING SCREW.

2.Turn FIXTURE to desired horizontal position.

3.Tighten LOCKING LEVER.

SETTING VERTICAL ROTATION

1.Loosen SIDE KNOB.

2.Turn FIXTURE to desired vertical position. The FIXTURE adjust 90° in the vertical direction.

Do not force past the adjustability limits.

3.Tighten SIDE KNOB.

SETTING LAMP ROTATION

1.Loosen LAMP ADJUSTMENT KNOB a few turns.

2.Drive LAMP ADJUSTMENT KNOB in 180° slot.

3.Tighten LAMP ADJUSTMENT KNOB after LAMP is in desired position.

SETTING ACCESSORY ROTATION

1.Loosen ACCESSORY KNOB a few turns.

2.Rotate SNOOT to desired position. SNOOT rotates 360°.

3.Tighten ACCESSORY KNOB.

ACCESSORY SPRING

SNOOT

HORIZONTAL ROTATION

LAMP ROTATION

180° SLOT

LAMP ADJUSTMENT

KNOB

ACCESSORIES KNOB

ACCESSORIES

CROSSBLADE

SLOT

LOCKING

SCREWFEMALE RECEPTACLE

VERTICAL ROTATION

SIDE KNOB

SNOOT

ACCESSORIES ROTATION

Fig. 3

LIGHTOLIER a GENLYTE company.

631 Airport Road, Fall River, MA 02720

Lightolier 26556MPC ACCESSORIES Fig, CLOSE SNOOT OVER LAMP Fig, FIXTURE OPERATION Fig

Models: 26556MPC

IS:26556MPC

ACCESSORIES (Fig. 2)

CLOSE SNOOT OVER LAMP (Fig. 2)

FIXTURE OPERATION (Fig. 3)