Lightolier 6196 instruction sheet A1294, To minimize force required to support Iytespots . a

v

READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING FIXTURE

Thisfixtureisintendedforinstallationinaccordancewith the NationalElectricalCodeandlocalregulations.

Toassurefull compliance with local codes and regulations, check with your local electrical inspector before

installation. To prevent electrical shock, turn off electricity at fuse box before proceeding. Retain these instructions for maintenance reference.

INSTRUCTION SHEET NO.

IS:6196

A1294 Page 1 of 2

INSTRUCTIONS FOR ATTACHING COIL CORD CLAMP-ON MONOPOINT

FOR USE WITH LIGHTOLIER TRACK FIXTURES ONLY

ATTACHING COILEDCORDCLAMP-ON MONOPOINT	TIGHTENING KNOB
TO PIPE ORPIPE STRUCTURE

This CLAMP is designed to mount on round pipe, pipe structures,

or round supports. Secure the CLAMP to structure by tightening

the TIGHTENING KNOB and the body allowed to face downward

to minimize force required to support I_ytespots (Fig. 1). A (3)

prong 120V, 60 Hz, grounded receptacle is required to energize

the unit,

AllACHING LYTESPOTWITH “T’ADAPTORTO COIL

CORDCLAMP

1.Position LEVER as shown in Fig. 2,

2.Align BEAD on MONOPOINT ADAPTOR with GROOVE in “T” adaptor, see Fig. 2 (If BEAD is NOT aligned, a potential hazard may result). Rotate LEVER 90 degrees to secure Lytespot.

3.To remove !_ytespot: Hold fixture and rotate LEVER 90 degrees (Fig. 3).

CAUTION- INJURY TO PERSONS AND DAMAGE TO THE LAMP AND/OR MOUNTING SURFACE MAY RESULT IF THE LAMP IS PULLED FROM THE SURFACE. TO REDUCE THE LIKELIHOOD OF SUCH INJURY OR DAMAGE, MOUNT ONLY ON A SURFACE THAT IS MECHANICALLY SOUND.

,,

‘T” ADAPTOR(lDIA. SHAIT)

PIPE OUTSlOE

DIAMETER 5/8” TO 2“

RECOMMENCED

CLAMP

MONOPOINT

AOAPTOR

FIG. 1

co

GAS

FIG. 2 GROUNO

uJSEDWITHCAT.NO.S6435& 7599

BOX ADAPTOR

zE

NOTE:Not designed to work with

COIL CORD CLAMP-ON MONOPOINT

FIG. 4 FIG. 3

1-IC3H TC> L IE R“E~~~~f~;,N~~