Lightolier 7589AZ instruction sheet Instructions for Lytespan Attachment Fitting, Assembly

(

INSTRUCTIONS FOR LYTESPAN ATTACHMENT

FITTING

I

INSTRUCTION SHEET NO

lS:7589AZ

ROW

/- SILVERED CONTACT

A. CORD PENDANT MOUNTING (supports up to 10 Ibs.)

I.Unscrew LEVER. Remove PLUG ASSEMBLY, HOUSING INSERT from attachment HOUSING. See Fig. 1.

2. See “WIRING PROCEDURE” below.

‘RASSCoNTACT----kc		<
		‘“~	:::~;
		,SJQ/
	!	f
GREEN GROUND		“~F’=
	>;,		PLUG ASSEMBLY
LEAD		1

B. STEM MOUNTING USING 1/2” O.D. TUBING

(supports up to 25 Ibs.)

I.Unscrew LEVER, STRAIN RELIEF CAP and KNURLED

RING Remove PLUG ASSEMBLY, HOUSING INSERT

from attachment HOUSING.

2.Use STEM TUBING with M-18 pipe thread

3A” long (not supplied). Screw KNURLED RING onto STEM TUBING. See Fig. 1A.

3.Insert STEM TUBING into attachment

HOUSING and screw on LOCKNUT until secure. Tighten KNURLED RING to lock in place.

4.See “WIRING PROCEDURE’’ below.

$3 “ ~i

w,,,-’”

CONNECTOR

‘REEN ‘ROuND --=& \

LEAD

$3W27 /’-LEvER

c. CHAIN MOUNTING (supports up to 25 Ibs..)

1. Unscrew LEVER and STRAIN RELIEF CAP.

Remove PLUG ASSEMBLY, HOUSING INSERT from attachment HOUSING.

2.Replace STRAIN RELIEF CAP with %-18 CHAIN LOOP (not supplied). See Fig. lB.

3.See “WIRING PROCEDURE” below.

D.WIRING PROCEDURE

1.Remove 2“of outer insulation from FIXTURE CORD

(when required) and strip conductor ends 3A”. See Fig. 1.

2.Insert FIXTURE CORD through attachment housing.

Fasten BLACK WIRE to LONGER (BRASS) CONTACT and WHITE WIRE to SHORTER (SILVERED) contact. For

3 conductor cord, splice GROUND LEADS with wire connector. (If the GROUND LEAD from the attachment HOUSING is not used, leave wire connector on.) See Fig. t

KNURLED	RING —
STRAIN	RELIEF		SET SCREW
			~,xTuRE
	~
CAP
			CORD
	FIG.	1
KNURLED	CHAIN		s<
	LOOP		KNURLED
RING
	(by	others)

*

~	sT~~
	TUBING
STEM	8
MOUNTING	CHAIN
	MOUNTING

CAUTION: OBSERVE POLARITY WHEN

FASTENING WIRES. BEND WIRES AROUND

SCREW IN CLOCKWISE DIRECTION.

3.Pull FIXTURE CORD back through attachment HOUSING and push HOUSING INSERT and PLUG ASSEMBLY into HOUSING (silvered contact in PLUG ASSEMBLY facing grooved side of attachment HOUSING). Push ground leads into area between SPRING section. Fig. 2.

4.Allow fixture cord to extend into attachment HOUSING by 1/6” and tighten PLASTIC SET SCREW, Fig. 2.

CAUTION: TIGHTEN ENOUGH TO SUPPORT

ASSEMBLY.

5.Screw LEVER into PLUG ASSEMBLY.

[m[<>[=[~<>[ml[~l~

GROOVE

LEVER

	--’4 l\	TIC SET
FIXTURE		SCREW
CORD
	~ ~ >	STRAIN RELIEF
		CAP

FIG. 2

‘@ SECAUCUS, NEW JERSEY, 07096 ”0508

MONTREAL,QUEBEC, CANAD~