c.TO REVERSE TRIM FRAME
Disenaaae TRIM FRAME from RETAINER by forcin~ ~ small screwdriver into space between TRIM FRAME and RETAINER near one of BOSSES and pry out. Repeat near the other two BOSSES until TRIM FRAME is free. Reverse TRIM FRAME and snap it back over RETAINER until RETAINER’S lip falls into space between upper and lower BOSSES.
D.TO INSTALL AND WIRE FIXTURE
1.Wire to supply leads. White fixture lead to neutral supply lead. Black fixture lead to hot (120V.) supply lead. Bare fixture wire to supp- ly ground. Use wirenuts (local hardware
items). Place all electrical connections in the
2.To insure a neat installation, keep LENS BEZEL in carton; insert paint shield in DUO- CAST REVERSIBLE TRIM FRAME to protect inside of fixture from paint, plaster and dust. Remove after construction is complete.
3.Adjust fixture for correct wattage. This fixture is set at the factory for the smallest lamp size. For other lamp sizes as desired (see ar- chitect’s or engineer’s plans). Compress RE- TAINING SPRING and push ADJUSTABLE SOCKET HOUSING upward until RETAINING SPRING engages to slot for the required
lamp/wattage position. (See Fig. 4 and 5.)
4.Set
for flange or flangeless installation in accor- dance with Step A.
5.After ceiling is completed, attach LENS BEZEL by squeezing TORSIONTITE SPRINGS together and insert through slots in housing; push up to ceiling.
6.To attach LENS BEZEL, squeeze TORSION- TITE SPRINGS together and insert through slots in housing (Fig. 3); push up to ceiling.
7.To relamp, simply push lens up and grip edge of bezel. Then pull down (Fig. 6).
/
FIG. 6 TO RELAMP
IS7790
RETAINER RING R0692
Page 2 of 2
VERSIBLE
REVERSIBLE
TRIM FRAME
n
.-
LENS BEZEL
FIG. | 3 | |
| ;:TT;;T | |
LAM PIWATTAG E |
| |
POSITION LABEL | .. | |
(INSIDE NECK) | . | |
| ||
LAM P/WAITAG E | $ | |
POSITION MARKING | ||
| ||
(OUTSIDE NECK) M |
| |
FIG. | 4 |
OPTICAL
SECTION
& FINGER
| J | HOLE |
RETAINING |
| |
SPRING |
|
FIG. 5
