Lightolier 8021DW Position Kick Reflectors, Push-In, Care And Maintenance Of Alzak Reflector

READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING FIXTURE

This fixture is intended for installation in accordance with the National Electrical Code and local regulations. To assure full compliance with local codes and regulations, check with your local electrical inspector before installation. To prevent electrical shock, turn off electricity at fuse box before proceeding.

Retain these instructions for maintenance reference.

INSTRUCTION SHEET NO.

IS:8021DW

A0399 Page 2 of 2

7. POSITION KICK REFLECTORS	KICK REFLECTOR		WALL
a.) After KICK REFLECTORS are properly assembled to
CLIPS, rotate RING to align KICK REFLECTORS
opposite walls to be illuminated.
For double wall washer see (Fig. 6).		FIG. 6
For corner wall washer see (Fig. 7).

8.	PUSH-IN	WALL
	a.) For overlapping flange installation (Fig. 8), slip WHITE
	TRIM RING over REFLECTOR. For Flangeless (Fig. 9)	KICK
	and Self Flanged Trims, WHITE TRIM RING is not
		REFLECTOR
	required.	WALL
	b.) Push REFLECTOR straight up to engage 3 RETAINING
	SPRINGS.	FIG. 7
	For double wall washer see (Fig. 10).
	For corner wall washer see (Fig. 11).	WHITE TRIM
	c.) Final adjustment can be achieved by rotating REFLEC-	RING
	TOR. NOTE: To remove REFLECTOR squeeze RETAIN-
	ING SPRINGS to disengage top portion of reflector.

9. CARE AND MAINTENANCE OF ALZAK REFLECTOR
REFLECTOR surfaces can be cleaned by the following
methods:	FIG. 8	FIG. 9
a.) Wipe off with a soft, clean, dry, lint-free cloth.
b.) Wipe off with a soft clean cloth dampened in mild
detergent solution. Rinse, the wipe dry with lint-free
cloth or paper towel.
c.) Wipe off with a clean cloth dampened with a solution
of wetting agent and water (such as 2 oz. per gallon
“Pluronic L62-LF” by Wyandotte Products). Then wipe
dry.
		RETAINING
		SPRINGS
		REFLECTOR
		FIG. 10
	RETAINING
	SPRINGS
	REFLECTOR

US & FOREIGN PAT. PENDING

FIG. 11

®LIGHTOLIER a GENLYTE THOMAS company. 631 Airport Road, Fall River, MA 02720