Instruction Sheet Number IS:8031
Page 1 of 2 | Installation of Calculite® Compact Fluorescent Downlights and Wall Washer Reflector Trims |
Read and understand these instructions before installing fixture.
This fixture is intended for installation in accordance with the National Electrical Code and local regulations. To assure full compliance with local codes and regulations, check with your local electrical inspector before installation. To prevent electrical shock, turn off electricity at fuse box before proceeding.
Retain these instructions for maintenance reference.
Warranty information on back – retain this sheet.
REFLECTOR OR LENS TRIM
INSTALLATION OF LENS WALL WASHER
AND OPEN WALL WASHER
required.
REFLECTOR OR LENS TRIM
A. INSTALL WHITE TRIM RING (FIG. 1, 2, 3 & 4) NOTE: Omit this section if reflector is
1.For overlapping trim installation (Fig 1) slip White Trim Ring over Reflector, as shown in Fig 2 & 3.
2.For flangless trim installation (Fig 4), White Trim Ring is not required.
B. SNAP-IN (FIG. 5)
Engage Retaining Spring into Slots in Reflector (see FIG. 5) following chart below. See
C. PUSH-UP REFLECTOR (FIG. 6 & 7)
Tilt Reflector and insert Socket Cup into ceiling opening on side opposite Junction Box. Pivot Reflector and push it up into ceiling (FIG 6).
NOTE: To remove Reflector, disengage the Socket Cup by depressing the Retaining Spring (FIG. 5). Turn Reflector counterclockwise while pulling downward. After starting, use both hands to remove, see FIG 7.
White
Trim
Ring
Reflector or
Lens Trim
FigIG..1FigIG.. 22
White
Trim
Ring
FigFIG. .33FigIG..44
Slot
Socket Cup
Fig. 5
Retaining Spring
Reflector
D. LAMPING (FIG. 8)
NOTE: See Socket Cup Label for lamping information.
Line up Lamp Pins with Socket, tilt lamp base to engage, then bring lamp to horizontal position and push into Socket (FIG. 8). To relamp,
CAREFULLY PULL STRAIGHT OUT OF SOCKET WITH ONE FINGER PLACED ON THE TOP OF THE LAMP.
CARE AND MAINTENANCE OF ALZAK REFLECTOR
If you must handle the anodized or Alzak reflectors, we recommend using clean white or plastic film gloves to avoid fingerprints.
Anodized or Alzak surfaces can be cleaned by the following methods:
1.Wipe off with a soft, clean, dry,
2.Wipe off with a soft clean cloth dampened in mild detergent.
3.Wipe off with a clean cloth dampened with a solution of wetting agent and water (such as 2 oz. per gallon “Pluronic
4.Or use a liquid wash such as Glass Wax®. Avoid gritty cleaning agents.
Socket
Cup
Reflector
Fig. 6
FIG. 6
To Remove
Junction
Box
Fig. 7
FIG. 7
| Fig. 8 |
| FIG. 8 |
Lightolier a Genlyte company | www.lightolier.com |
631 Airport Road, Fall River, MA 02720 • (508)
© 2006 Genlyte Group LLC • B0306