Lightolier 8037TB instruction sheet Remove Louver Fig, Install Socket CUP or Bracket a

READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING FIXTURE

This fixture is intended for installation in accordance with the National Electrical Code and local regula- tions. To assure full compliance with local codes and regulations, check with your local electrical inspector before installation. To prevent electrical shock, turn off electricity at fuse box before proceeding.

Retain these instructions for maintenance reference.

INSTRUCTION SHEET NO.

IS:8037TB

0597 Page 1 of 2

INSTALLATION PROCEDURE FOR CALCULITE® COMPACT FLUORESCENT

REFLECTOR TRIMS LOUVERED: 8037TB, 8038TB AND 8069 (TRIPLE TUBE) SERIES

WARNING: (RISK OF FIRE) DO NOT INSTALL INSULATION WITHIN 3” OF FIXTURE SIDES OR WIRING COMPARTMENT, NOR ABOVE FIXTURE IN SUCH A MANNER SO AS TO ENTRAP HEAT.

A. REMOVE LOUVER (Fig. 1)

Pull LOUVER down from REFLECTOR.

B.INSTALL SOCKET CUP OR BRACKET (Fig. 2a)

Align tabs on SOCKET CUP with openings in REFLECTOR and push in SOCKET CUP until RETAINING SPRING snaps in. Place SOCKET BRACKET STUDS through holes in REFLECTOR. Secure BRACKET from inside REFLECTOR with two supplied nuts.(Fig. 2b)

C.PUSH-UP REFLECTOR HOUSING (Fig. 3)

Tilt REFLECTOR and insert SOCKET CUP into ceiling opening on side opposite JUNCTION BOX. Pivot REFLECTOR and push it up into ceiling.

NOTE: To remove REFLECTOR disengage the SOCKET CUP by depressing the RETAINING SPRING. (Fig. 2) Turn REFLECTOR counterclockwise while pulling downward. After starting, use both hands to remove, if desired. (Fig. 4)

D.LAMPING (Fig. 5)

Note: See SOCKET CUP for lamping information.

Tilt lamp base to engage, line up LAMP PINS with SOCKET. Bring lamp to horizontal position and push into SOCKET. (Fig. 5) To relamp, carefully pull straight out of SOCKET with one finger place on the tip of the lamp to prevent hitting the REFLECTOR.

E.ATTACH LOUVER (Fig. 6)

Align SPRINGS in LOUVER with SLOT in REFLECTOR. Gently push LOUVER straight up until SPRINGS snap into SLOTS in

REFLECTOR.

REFLECTOR

LOU-

Fig. 1

SOCKET

BRACKET

STUD

REFLECTOR

Fig. 2b

TO REMOVE

Fig. 4

SOCKET SLOT

CUPRETAINING SPRING

Fig. 2a	REFLEC-
SOCK-	JUNCTION
ET	BOX

Fig. 3	REFLECTOR
	SOCKET

Fig. 5

WARNING: USE ONLY WITH FRAME-IN KITS PROVIDED BY LIGHTOLIER. USE OF OTHER MANUFACTURERS’ FRAME-IN KITS VOIDS THE UNDERWRITERS LABORATORIES LISTING AND COULD CONSTITUTE A FIRE HAZARD.

REFLECTOR
LOUVER	SLOT IN REFLECTOR
Fig. 6	SPRIN

®

FALL RIVER, MASSACHUSETTS 02720