Additional information | 12 |
SIRIUS radio messages
Symptom | Cause | Action | |||
Antenna Error | Antenna is not properly connected. | Check that the antenna cable is | |||
|
|
|
| attached securely. | |
|
|
|
|
|
|
Check Sirius Tuner | SIRIUS Connect tuner is not properly connected | Check that the 8 pin mini DIN cable | |||
|
|
|
| and AC Adapter are attached securely. | |
|
|
|
|
|
|
Acquiring Signal | The SIRIUS signal is too weak at the current | n/a | |||
| location. |
|
| ||
|
|
|
|
|
|
Subscription Updating | Unit is updating subscription. | Wait until the encryption code has | |||
|
|
|
| been updated. | |
|
|
|
|
|
|
Updating Channels | Unit is updating channels. | Wait until the encryption code has | |||
|
|
|
| been updated. | |
|
|
|
|
|
|
Invalid Channel | Selected channel is not available/does not exist. | Select another channel. | |||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
English Deutsch Français
Resetting the main unit
Use this procedure to reset all the receiver’s settings to the factory default. Use the front panel controls to do this.
1Switch the receiver into standby.
2While holding down the TONE button, press and hold the STANDBY/ON button for about three seconds.
3When you see RESET? appear in the display, press ENTER.
OK? shows in the display.
4Press SETUP to confirm.
OK appears in the display to indicate that the receiver has been reset to the factory settings.
Switching the speaker impedance
We recommend using speakers of 8 Ω with this system, but it is possible to switch the impedance setting if you plan to use speakers with a 6 Ω impedance rating.
•With the receiver in standby, press
STANDBY/ON while holding down the SPEAKERS button.
Each time you do this, you switch between the impedance settings:
•SP 6 OHM – Use this setting if your speakers are rated at 6 Ω.
•SP 8 OHM – Use this setting if your speakers are rated at 8 Ω or more.
Italiano Nederlands Español
69
En
