Kenwood 144, 440 MHz TH-D7A instruction manual Short, Default, Parameter, Description, Persist

Command Name	Short	Default	Parameter	Description
PERSIST	PE	128	0 ~ 255	Specifies a parameter to calculate probability for the
				PERSIST/SLOTTIME method.
PPERSIST	PP	ON	ON/ OFF	Causes the TNC to use the PERSIST/SLOTTIME method
				when ON, or the DWAIT method when OFF.
RESET	RESET	—	—	Restores the default status for all the commands.
RESPTIME	RES	5	0 ~ 250	Specifies the acknowledgment packet transmission delay.
				The unit of the parameter is 100 milliseconds.
RESTART	RESTART	—	—	Causes the TNC to function as if it is switched OFF then ON.
				Specifies the number of transmission retries. If packets are
RETRY	RE	10	0 ~ 15	not correctly accepted while in connection, a connect request
				is sent again after the specified number of retries.
SENDPAC	SE	$0D	0 ~ $7F	Specifies a character which forces a packet to be sent.
				Specifies the period of random number generation intervals
SLOTTIME	SL	3	0 ~ 250	for the PERSIST/SLOTTIME method. The unit of the
				parameter is 10 milliseconds.
TRACE	TRAC	OFF	ON/ OFF	When ON, causes the TNC to display all received packets in
				their entirety.
TRIES	TRI	0	0 ~ 15	Specifies the number of transmission retries programmed in
				the retry counter.
TXDELAY	TX	50	0 ~ 120	Specifies the time delay between PTT ON and start of
				transmission. The unit of the parameter is 10 milliseconds.
			Call1 (VIA	Specifies call signs to send a packet in Unprotocol mode.
UNPROTO	U	CQ	call2, call3, ...	Call1 is the call sign of the destination. Call2 to call9 are call
			call9)	signs of stations to be digipeated through.
XFLOW	X	ON	ON/ OFF	Causes the TNC to perform software flow control when ON, or
				hardware flow control when OFF.

102