Kenwood TH-D7A, 144 Press BAL, then UP/ DWN to, Problem, Probable Cause, Corrective Action

Problem		Probable Cause		Corrective Action	Ref. Page
You cannot transmit by	1	You selected a frequency outside	1	Select a frequency within the	7
pressing the PTT		the allowable transmit frequency		allowable transmit frequency range.
switch.		range.
	2	You selected a transmit offset that	2	Press [F], [MHz] repeatedly so neither	21
		places the transmit frequency		“+” nor “–” is visible.
		outside the allowable range.
	3	TX Inhibit is ON.	3	Access Menu 1–5–5 and select “OFF”.	51
	4	Tone Alert is ON.	4	Press [F], [ENT] to switch OFF Tone	47
				Alert.
	5	Packet data was being transmitted	5	Press the PTT switch after transmitting	—
		using the data band.		of packet data is completed.
The transceiver	The Automatic Power Off (APO)		Switch OFF the APO function.		49
switches OFF for no	function is ON.
apparent reason.
Turning the VOL control	The speaker for the band you wanted		Press [BAL], then [UP]/ [DWN] to		48
does not allow you to	to monitor was muted.		correctly adjust the volume balance
hear audio.			between the two bands.
Packet operation results	1	The squelch is open.	1	Select the correct squelch level so that	8
in no connects with				the squelch is opened only when
other stations.				signals are present.
	2	You did not select the same	2	Use HBAUD command to select the	54
		transfer rate as the target station.		appropriate transfer rate.

1

2

3

4

5

6

7

8

9

10

11

12

13

14

15

16

17

18

19

20

21

22

23

91