Kenwood 440 MHz TH-D7A, 144 instruction manual Tone Alert, Beep On/Off

TONE ALERT

Tone Alert provides an audible alarm when signals are received on the frequency you are monitoring. In addition, it shows the number of hours and minutes elapsed after signals were received. If you use Tone Alert with CTCSS, it alarms only when a received CTCSS tone matches the tone you selected.

1Press [A/B] to select band A or B.

•If necessary, press [F], [A/B] to recall the sub-band.

2Press [F], [ENT] to switch Tone Alert ON (or OFF).

•A bell icon appears when Tone Alert is ON.

STA CON PACKET96 BCONDUP

5 7 9

•When a signal is received, an alarm sounds and the bell icon starts blinking.

•Pressing the PTT switch while the bell icon is blinking switches Tone Alert OFF.

•When 99 hours and 59 minutes pass after a signal is received, counting stops.

•Each time a new signal is received, the time resets to 00.00.

Note:

◆While Tone Alert is ON, there is no speaker output when a signal is received. To hear receive audio, press and hold [MONI].

◆When Tone Alert is ON, APO does not turn the power OFF.

◆When Tone Alert is ON, you can use only the following functions:

•	Lamp ON	•	Lamp Latch ON
•	Monitor	•	Band A/B Select

•Squelch Level Select

BEEP ON/OFF

The transceiver beeps each time you press a key on the keypad. You can also switch this function OFF. Access Menu 1–5–3 (BEEP) and select “OFF”. The default is “ALL”.

In Menu 1–5–3 you can also select “KEY” and “KEY+NEW DATA”. Those settings are described in “APRS” sections {pages 63 and 77}.

1

2

3

4

5

6

7

8

9

10

11

12

13

14

15

16

17

18

19

20

21

22

23

47