Kenwood 144, TH-D7A Appendix, Tnc Commands List, Short, Description, Default, Parameter

APPENDIX

TNC COMMANDS LIST

The commands supported by the built-in TNC are listed below. You must enter a space between a command name (or short-form) and a parameter, or between two parameters; ex. AU OFF, BEACON EVERY 18.

Command Name	Short	Default	Parameter	Description
AUTOLF	AU	ON	ON/ OFF	When ON, sends a line feed (LF) to the computer after each
				carriage return (CR).
			EVERY/	If set to EVERY, sends a beacon packet at intervals of the
				specified period (n). If set to AFTER, sends a beacon packet
BEACON	B	EVERY 0	AFTER n
				only once after the specified period (n). The unit of n is
			(n = 0 ~ 250)
				10 seconds.
BTEXT	BT	—	0 ~ 159	Specifies the content of the data portion of a beacon packet.
			characters
CALIBRAT	CAL	—	—	Sends a space/mark square wave (50/50 ratio). Enter Q to
				exit Calibrate mode and restore the Command mode.
CHECK	CH	30	0 ~ 250	Specifies the interval from signal drop-out until execution of
				disconnection. The unit of the parameter is 10 seconds.
			Call1 (VIA	Sends a connect request. Call1 is the call sign of the station
CONNECT	C	—	call2, call3, ...	to be connected to. Call2 to call9 are call signs of stations to
			call9)	be digipeated through.
CONVERSE	CONV	—	—	Causes the TNC to enter Converse mode. Press [Ctrl]+[C] to
	or K			restore the Command mode.
CPACTIME	CP	OFF	ON/ OFF	When ON and in Converse mode, sends a packet at intervals
				of the period determined by PACTIME.
CR	CR	ON	ON/ OFF	When ON, appends a carriage return (CR) to all packets to be
				sent.
DISCONNE	D	—	—	Sends a disconnect request.

99