Kenwood 440 MHz TH-D7A, 144 instruction manual Control Operation, Press PTT+MR+ POWER ON

1

6 Turn the transceiver power OFF.

7 Press [PTT]+[MR]+ POWER ON.

• The transceiver enters Remote Control mode. “MOBILE

CONTROL OPERATION

When in Remote Control mode, the keys of the handy transceiver will function as below. Each time you press

2CTRL” appears.

STA CON 96 BCONDUP

4	5	7	9
5
6
7

8• To exit Remote control mode, repeat steps 6 and 7.

9On the mobile transceiver:

108 Program the DTSS code on the UHF band as the

11secret number.

12• Select the same number as you selected in step 2.

•For the programming method, refer to the instruction

13manual for the mobile transceiver.

149 Select the receive frequency on the UHF band.

15

• Mate this frequency with the transmit frequency on the

16handy transceiver.

1710 Make the transceiver enter Remote Control mode.

18• For the method, refer to the instruction manual for the

19mobile transceiver. If not described, consult your authorized KENWOOD dealer, customer service, or

20service center.

21

22

23

the desired key, the handy transceiver will automatically enter transmit mode and send the corresponding command to the mobile transceiver.

1TM-V7A: REV ON/ OFF

2Switches Cross-band Repeater ON/ OFF if the mobile transceiver has the function.

To change the transmit/ receive frequency:

([VFO] ➡ [ENT] ➡ [0] ~ [9] (enter the necessary digits)

➡[ENT]) or ([VFO] ➡ [UP]/ [DWN]) To recall a memory channel:

([MR] ➡ [ENT] ➡ [0] ~ [9] (enter the necessary digits) ➡ [ENT]) or ([MR] ➡ [UP]/ [DWN])

To change the tone (or CTCSS) frequency:

([TONE SEL] ➡ [0] ~ [9] (enter 2 digits; ex. [0], [5]) ➡ [TONE SEL])

•Use Nos. 01 to 38 shown in the table in page 22.

•Your mobile transceiver may require you to first activate the Tone or CTCSS function. It may also allow you to program a separate tone and CTCSS frequency. Check the instruction manual for the mobile transceiver.

82