Note: The illustration above may differ slightly from your server.
To remove the
1.
2.Unplug the server.
3.Remove the front bezel (see “Removing the bezel” on page 60).
4.Remove the cover (see “Removing the side cover” on page 59).
5.Remove the support bracket (see “Removing the support bracket assembly” on page 61).
6.Remove any hard disk drives or drive fillers from the drives.
7.Disconnect the hard disk drive cables that connect to the system board.
8.Swing the cage out.
9.Slide the backplane out of the cage.
Power supply
Before you begin:
•Read “Safety information” on page 133.
•Review the information in “Before you begin” on page 58.
FRU information (service only) 99
