a.Insert a small,
b.Press down and in with the screwdriver handle to remove the
c.Firmly grasp the fan sink and lift it off the microprocessor. Store the fan sink in a safe, clean place with the bottom side up. The thermal material on the fan sink must stay clean if you intend to reuse the fan sink in the future.
d.Disconnect the
•If you are removing the microprocessor from connector U11, disconnect the
•If you are removing the microprocessor from connector U12, disconnect the
7.Lift up the release lever and remove the microprocessor from the connector. Store the microprocessor in a
8.If you are installing a new microprocessor, go to “Installing a microprocessor” on page 78.
9.If you are not replacing the microprocessor:
a.Reinstall the terminator card in the empty microprocessor connector.
b.Press the release lever down to lock the terminator card into place.
c.Remove the VRM from the appropriate VRM connector:
•If you removed the microprocessor from connector U11, press down on the latches on either side of connector J12, and remove the VRM from connector J12.
•If you removed the microprocessor from connector U12, press down on the latches on either side of connector J42, and remove the VRM from connector J42.
10.If you have other options to install or remove, do so now; otherwise, replace the support bracket assembly; then, go to “Installing the cover”.
Installing the bezel
The following illustration shows how to install the bezel.
Note: The illustrations in this document might differ slightly from your hardware.
Do the following to install the bezel:
1.Insert the two tabs on the bottom of the bezel into the matching slots in the server chassis.
2.Push the top of the bezel toward the server until the two tabs at the top of the bezel snap into place.
Installing the cover
The following information describes the cover installation procedure.
Note: The illustrations in this document might differ slightly from your hardware.
