IBM XSERIES 220 manual Hardware Maintenance Manual xSeries

8.If you are installing a microprocessor that has a speed lower than 933 MHz, install the heat sink onto the microprocessor:

Terminator card

VRM 2 (J12)

Microprocessor 1

Microprocessor 2

VRM 1 (J42)

Heat sink

Heat-sink retainer

a.Peel the plastic protective strip off the bottom of the heat sink. Make sure that the square of thermal material is still on the bottom of the heat sink.

b.Align and place the heat sink on top of the microprocessor.

c.Align and place the heat-sink retainer (clip) over the heat sink; then, snap it into place.

d.Continue with step 10 on page 81.

80Hardware Maintenance Manual: xSeries 220