IBM XSERIES 220 manual NetWare driver messages for the Ethernet controller

Message		Description
Duplicate slot numbers	Explanation: An attempt has been made to bind the same
detected.	slot number more than once.
	Action: Check the slot numbers entered during the bind.
	Adapter slot numbers must be valid and unique. If the
	problem persists, contact your network supplier.
’Xxx’ is not supported for	Explanation: A bind command has been issued for adapters
AFT team.	not supported by AFT.NLM.
	Action: Make sure that you attempt to bind only adapters
	supported by AFT.NLM.
Primary and Secondary	Explanation: A bind command was entered for an adapter
adapters do not match. AFT	team that is a combination of server and client adapters. An
group is not created.	AFT team must be a grouping of the same classification of
	adapter.
	Action: Verify that all the adapters bound in a team are of the
	same classification.
Requested number of	Explanation: The number of adapters specified in the bind
Secondary cards are not	command could not be located.
found.	Action: Verify the numbers and slot locations of the adapters
	to be bound. If the problem persists, contact your network
	supplier.
Failed to create AFT group.	Explanation: Binding of protocol failed. Protocol is either not
Make sure that the drivers	bound to any adapter or is bound to more than one adapter in
for supported adapters are	the group.
loaded, primary adapter is	Action: Ensure that the protocol is bound to only adapter in
bound to protocols, and	an AFT team.
secondary adapter is not
bound to any protocols.
Error identifying slot	Explanation: The mapping between the board name entered
numbers for the specified	and the slot number for an adapter could not be established.
board names.	Action: Check the board name for the adapter before issuing
	the bind command. If the problem persists, contact your
	network supplier.
Can’t unbind specified slot	Explanation: The number entered in the unbind command
from AFT group. Make sure	was not the primary adapter in an AFT group.
that the slot you specified is	Action: Reissue the unbind command and specify the slot
for the primary adapter in an	number for the primary adapter.
AFT group.
LAN adapter at slot nnnn	Explanation: The adapter that you specified could not be
(Port 0xaa) failed to reset.	initialized.
Check the state of the	Action:
adapter.	1.	Load the driver for the supported adapter.
	2.	Check that the adapter is seated properly in the slot and
		try loading the AFT module again.
	If the problem persists, contact your network supplier.
AFT is not supported on this	Explanation: The NetWare on your server is not a version
version of NetWare™.	supported by AFT.
	Action: Load and bind AFT only on supported versions of
	NetWare (currently version 4.11 and above).

Table 4. NetWare driver messages for the Ethernet controller.

24Hardware Maintenance Manual: xSeries 220