IBM XSERIES 220 manual Error code Description Hex, Networks Adapters, Select Properties Advanced

Message	Description
Failed to allocate resources	Explanation: An unknown error has occurred when trying
tags.	to allocate needed resources for the AFT module.
	Action: Check Server Configuration. If the problem persists,
	contact your network supplier.
Please unload all LAN	Explanation: An attempt was made to unload the AFT.NLM
drivers before unloading	module before unloading the adapter driver.
AFT.NLM.	Action: Unload the adapter driver before unloading the AFT
	module.

Table 4. NetWare driver messages for the Ethernet controller.

NDIS 4.0 (Windows NT) driver messages

This section contains the error messages for the NDIS 4.0 drivers. The explanation and recommended action are included with each message.

Error code		Description
(hex)
0x00	Explanation: The driver could not register the specified interrupt.
	Action: Using the Configuration/Setup Utility, make sure that a PCI
	interrupt is assigned to your Ethernet card, and that Ethernet is enabled.
0x01	Explanation: One of the PCI cards did not get the required resources.
	Action: Using the Configuration/Setup Utility, make sure that a PCI
	interrupt is assigned to your Ethernet card, and that Ethernet is enabled.
0x02	Explanation: Bad node address (multicast address).
	Action: Make sure the locally administered address is valid, if one is
	specified. The address can not be a multicast address.
0x03	Explanation: Failed self-test.
	Action: Make sure a cable is attached to the Ethernet connector. If the
	problem persists, call for service.
0x0D	Explanation: Could not allocate enough memory for transmit queues.
	Action:
	1.	From the Windows NT desktop, select Start -> Control Panel ->
		Networks -> Adapters.
	2.	Select your IBM Ethernet adapter from the list.
	3.	Select Properties -> Advanced.
	4.	Lower the resource values that apply to the transmit queue.
0x0E	Explanation: Could not allocate enough memory for receive queue.
	Action:
	1.	From the Windows NT desktop, select Start -> Control Panel ->
		Networks -> Adapters.
	2.	Select your IBM Ethernet adapter from the list.
	3.	Select Properties -> Advanced.
	4.	Lower the resource values that apply to the receive queue.

Table 5. NDIS (Windows NT or Windows 2000) driver messages for the Ethernet controller.

Diagnostics 25