2.The Devices and I/O Ports choice appears only on the full Configuration/Setup Utility menu. If you have set both levels of passwords (user and administrator), you must type the administrator password to access the full Configuration/Setup Utility menu.
Parallel port
The server has one parallel port. This port supports three standard Institute of Electrical and Electronics Engineers (IEEE) 1284 modes of operation: Standard Parallel Port (SPP), Enhanced Parallel Port (EPP), and Extended Capability Port (ECP).
Viewing or changing the port assignments
You can use the Configuration/Setup Utility program to configure the parallel port as bidirectional; that is, so that data can be both read from and written to a device. In bidirectional mode, the server supports the ECP and EPP modes.
To view or change the
1.Restart the server and watch the monitor screen.
2.When the message Press F1 for Configuration/Setup appears, press F1.
3.From the main menu, select Devices and I/O Ports; then, press Enter.
4.Select the parallel port; then, use the arrow keys to advance through the available settings.
Note: When you configure the parallel port as bidirectional, use an IEEE 1284- compliant cable. The maximum length of the cable must not exceed 3 meters (9.8 feet).
5.Select Save Settings; then, select Exit Setup to exit from the Configuration/Setup Utility main menu.
