IBM XSERIES 220 manual Removing the right-side cover

12.Remove the right-side cover.

a.From the rear of the system, remove the four screws that hold the right-side cover in place. Save all four screws for installing the new bottom cover.

Right-side cover

Figure 10. Removing the right-side cover

b.Slide the right-side cover toward the rear of the system to remove it. Store the cover for possible future use.

13.Install the new bottom cover that comes with the conversion kit.

a.Carefully turn the system so that the cover-release-latch side is down on a flat surface; then, align the bottom cover with the frame of the system.

Bottom cover

Power supply screw

Bottom cover screws

Figure 11. Installing the new bottom cover

b.Slide the cover toward the front of the system, making sure that the tabs on the front and rear of the cover fit into the slots on the system.

48Hardware Maintenance Manual: xSeries 220