IBM XSERIES 220 manual Removing the bezel

Cover-release latch

Key lock

Do the following to remove the left-side cover of the server:

1.Review the information in “Before you begin” on page 58.

2.Turn off the server and all attached devices and disconnect all external cables and power cords.

3.If necessary, unlock the server cover.

4.Pull out on the cover-release latch near the rear of the server cover; then, slide the cover toward the rear of the server and remove it.

Attention: For proper cooling and airflow, replace the cover before turning on the server. Operating the server for extended periods of time (over 30 minutes) with the cover removed might damage server components.

5.For a tower model, rotate the stabilizing feet on the bottom of the server, and place the server on its side to install or remove components.

Removing the bezel

The following illustration shows how to remove the bezel from the server.

Note: The illustrations in this document might differ slightly from your hardware.

60Hardware Maintenance Manual: xSeries 220