IBM XSERIES 220 11XX Disconnect external cable on serial port, 1800, Video Adapter if installed

Error Code/Symptom			FRU/Action
962		1.	Disconnect external cable on parallel port.
(Parallel port error)		2.	Run Configuration/Setup
		3.	System Board
11XX		1.	Disconnect external cable on serial port.
(System board serial port 1 or		2.	Run Configuration/Setup
2 error)
		3.	System Board
1162		1.	Disconnect external cable on serial port
(Serial port configuration		2.	Run Configuration/Setup
conflict)
		3.	System board
1200 (microprocessor		1.	Microprocessor
machine check)
1800		1.	Run Configuration/Setup
(No more hardware interrupt		2.	Failing Adapter
available for PCI adapter)
		3.	System Board
1962		1.	Verify a bootable operating system is installed.
(Drive does not contain a		2.	If RAID system, refer to the Hardware Maintenance Manual for the specific RAID
valid boot sector)
			adapter.
		3.	Run Diagnostics
		4.	Hard Disk Drive
		5.	Cable
		6.	SCSI Backplane
		7.	System Board
2400		1.	Video Adapter (if installed)
(Video controller test failure)		2.	System Board
2462	(Video memory	1.	Video Adapter (if installed)
configuration error)		2.	System Board
5962		1.	Run Configuration/Setup
(IDE CD-ROM configuration		2.	CD-ROM Drive
error)
		3.	CD-ROM Power Cable
		4.	IDE Cable
		5.	System Board
		6.	Battery
8603		1.	Pointing Device
(Pointing Device Error)		2.	System Board
00012000 (Processor machine		1.	Update BIOS
check)		2.	Replace microprocessor
00019501	(Microprocessor 1	1.	Microprocessor 1
is not functioning - check		2.	System Board
VRM and processor LEDs)
00019502 (Microprocessor 2		1.	Microprocessor 2
is not functioning - check		2.	System Board
VRM and processor LEDs)

122Hardware Maintenance Manual: xSeries 220