Ethernet port connector
The following table shows the pin-number assignments for the RJ-45 connector. These assignments apply to both 10BASE-T and 100BASE-TX devices.
Pin | Signal | Pin | Signal |
| | | |
1 | +Transmit data | 5 | Not connected |
| | | |
2 | -Transmit data | 6 | -Receive data |
| | | |
3 | +Receive data | 7 | Not connected |
| | | |
4 | Not connected | 8 | Not connected |
| | | |
Table 16. Ethernet RJ-45 connector pin-number assignments.
If you plan to use the Wake on LAN function in the server, you must install a Wake on LAN-enabled Ethernet NIC adapter in PCI slot 1, and use the Ethernet cable that comes with the Ethernet adapter to connect the Ethernet adapter to the system board. For additional information on the Wake on LAN function, adapters and cables, refer to the documentation that comes with the Ethernet adapters.
The following table shows the pin-number assignments for the Ethernet Wake on LAN PCI adapter power connector.
Pin | Signal |
| |
1 | +5 AUX |
| |
2 | Ground |
| |
3 | Not connected |
| |
Table 17. Wake on LAN PCI adapter power connector pin-number assignments.
96Hardware Maintenance Manual: xSeries 220
