1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
75
SELECTING BEACON TRANSMIT INTERVAL
Select an interval for automatically transmitting APRS
data. The default is 5 minutes.
1Press [MENU] to enter Menu mode.
2Press [2], [7] to select “2–7 (TX INTERVAL)”.
3Press [UP]/ [DWN] to select the desired interval.
The selectable intervals are .5, 1, 2, 3, 5, 10, 20, and 30
minutes.
4Press [OK] to complete the setting.
5Press [MENU] to exit Menu mode.
Note:
With “AUTO” in Menu 2–9 and Beacon ON, pressing [OK] in step 4
causes the APRS data to be immediately transmitted. After that, the
APRS data is transmitted at intervals of the selected period.
While signals are present, APRS data is not transmitted after the
interval. Approximately 2 seconds after signals drop, transmitting is
executed.
RESTRICTING RECEPTION OF APRS DATA
If APRS is popular in your country, you may receive too
many APRS packets for a short period. If this disturbs
your APRS activities, specify a distance from your
location. You will not receive APRS data from stations
beyond this distance.
1Press [MENU] to enter Menu mode.
2Press [2], [B] to select “2–B (POS LIMIT)”
3Press [UP]/ [DWN] to select the desired distance.
The selectable range is from 10 to 2500 in steps of 10,
plus OFF. The unit is mile or kilometer depending on the
selection in Menu 2–C (UNIT) {page 65}.
4Press [OK] to complete the setting.
5Press [MENU] to exit Menu mode.
STACON
96
BCON
DUP
9
7
5
STACON
96
BCON
DUP
9
7
5
STACON
96
BCON
DUP
9
7
5
STACON
96
BCON
DUP
9
7
5
TH-D7 E 61 APRS 98.12.4, 0:13 PM75