Kenwood TH-D7A Using Ctcss, Ctcss FREQ. ID, Press F, 3 to switch the Ctcss function on or, Off

USING CTCSS

11 Press [A/B] to select band A or B.

2• If necessary, press [F], [A/B] to recall the sub-band.

32 Press [F], [3] to switch the CTCSS function ON (or

OFF).
4
• “CT” appears when CTCSS is ON.
5
6	STA CON PACKET96 BCONDUP
5	7	9
7
8
9

10You will hear calls only when the selected tone is

11received. To answer the call, press and hold the PTT

12switch, then speak into the microphone.

13Note:

◆You cannot use the CTCSS and Tone functions simultaneously.

14Switching the CTCSS function ON after activating the Tone function

15		deactivates the Tone function.
	◆	If you select a high CTCSS frequency, receiving audio or noise that
16		contains the same frequency portions may cause CTCSS to function
17		incorrectly. To prevent noise from causing this problem, select an
		appropriate squelch level {page 8}.

18

19

20

21

22

23

CTCSS FREQ. ID

This function scans through all CTCSS frequencies to identify the incoming CTCSS frequency on a received signal. You may find it useful when you cannot recall the CTCSS frequency that the other persons in your group are using.

1Press [F], [4] (1 s) to activate the function.

• The CTCSS function is switched ON.

STA CON PACKET96 BCONDUP

5 7 9

•If you access “F–4 (CTCSS FREQ)” using [UP]/ [DWN] in Function Select mode, press [OK] (1 s) to activate the function.

•To reverse scan direction, press [UP] (upward scan) or [DWN] (downward scan).

•To quit the function, press [ESC].

•When the CTCSS frequency is identified, the identified frequency appears and blinks.

2Press [OK] to program the identified frequency in place of the currently set CTCSS frequency.

•The previous frequency display is restored with the CTCSS function remained ON.

•Press [ESC] if you do not want to program the identified frequency.

•Press [UP]/ [DWN] while the identified frequency is blinking, to resume scanning.

Note: Received signals are audible while scanning is in progress.

40