
READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING FIXTURE
This fixture is intended for installation in accordance with the National Electrical Code and local regulations. To assure full compliance with local codes and regulations, check with your local electrical inspector before installation. To prevent electrical shock, turn off electricity at fuse box before proceeding.
Retain these instructions for maintenance reference.
INSTRUCTION SHEET NO.
IS:8228
0499 | Page 1 of 2 |
INSTRUCTIONS FOR FIXTURES 8228, 8238, 8248, 8582, 8583, 8595, & ACCESSORIES INSTRUCTIONS FOR ASSEMBLING
TO INSTALL RING SHADE:
1.Line up shade’s NECK FLANGE with corresponding openings at inside diameter of ARM.
2.Push in and
3.Install indicated PAR lamp into shade (see LAMPING INFORMATION on page 2).
TO INSTALL ACCESSORIES INTO RING SHADES:
NOTE: RING SHADE plus an ACCESSORY HOLDER are required to install ACCESSORIES into fixtures. (The ACCESSORY HOLD- ERS are sold separately from the SHADES). For ACCESSORY information see ACCESSORIES chart on page 2. ACCESSORY HOLDER may be used without ACCESSORIES.
1. Before installing ACCESSORY HOLDER, assemble RING |
SHADE to the |
lamp (See above). |
2. Place the desired ACCESSORIES inside ACCESSORY |
HOLDER (A max. of two ACCESSORIES). Line up |
ACCESSORY HOLDER so that the SPRINGS are facing the |
FIXTURE ADAPTERS: 8701, 8704E, 8705E, 8706E, 8707E, 28701, & 28705E
ARM
NECK FLANGE
RING SHADE
FIXTURE ADAPTERS:
8201 & 8202
ARM
Fig. 1 | NECK FLANGE |
RING SHADE
Fig. 2
GROOVE
inside diameter of the RING SHADE. Push ACCESSORY |
HOLDER into shade until it snaps into the GROOVE |
(See Fig. 3 & 4). |
ACCESSORY HOLDER
SPRINGS
ACCESSORIES
optional (sold separately)
Fig. 3
GROOVE
SPRINGS
ACCESSORIES
optional (sold separately)
ACCESSORY HOLDER
Fig. 4
®LIGHTOLIER a GENLYTE THOMAS company. 631 Airport Road, Fall River, MA 02720